Part Number 1195702 HARNESS AS Fits for 5130 Mining Excavator

Part Number 1195702 HARNESS AS Fits for 5130 Mining Excavator

Product Name: Part NO.1195702 HARNESS AS
CCR: Y
FILTER: N
MAINT: N
For Model: 5130 Mining Excavator

Product Name: Part NO.1195702 HARNESS AS
CCR: Y
FILTER: N
MAINT: N
For Model: 5130 Mining Excavator

Part NO.1195702 HARNESS AS suitable for 1063614 WIRING GP-ELECTRONIC CONTROL
NPR: Y
  • SEQPart NO.NameMODEL
  • 19X73789X7378 SEAL-O-RING (8.92MM ID)
  • 28T42238T4223 WASHER-HARD-25.5MM OD X 13.5MM ID X 3MM
  • 38T41338T4133 NUT-ELBOW TO MANIFOLD
  • 48T41218T4121 WASHER-HARD (21.0 MM OD)
  • 58T41368T4136 BOLT-ALTERNATOR STRAP TO FAN DRIVE
  • 68P85408P8540 GROMMET 27 mm(1.06 in.) Wide
  • 77K11817K1181 STRAP USE AS REQUIRED
  • 88T41798T4179 BOLT (20mm LONG)
  • 99X82569X8256 WASHER (2.0MM THK)
  • 108T41378T4137 BOLT (M10 X 1.5 X 20MM)
  • 116Y65846Y6584 STRAP AS-GROUND
  • 123S20933S2093 STRAP-CABLE-TO TIE HARNESSES TOGETHER
  • 133E33653E3365 WEDGE-RECEPTACLE LOCK
  • 148T87298T8729 PIN-CONNECTOR
  • 1510288021028802 KIT-RECEPTACLE (2 PIN)
  • 165P41165P4116 WASHER 20.5mm(.75 in.)O.D.
  • 178T69128T6912 BOLT (50 mm LONG)
  • 188T36128T3612 NUT (M10) (WELD)
  • 198T42248T4224 WASHER-TO ASSEMBLE VALVE AS AND PLATES
  • 208T41858T4185 BOLT (M10 X 1.50 X 50 MM)
  • 216V81876V8187 NUT (1/4 X 28 THD)
  • 225P90855P9085 CLIP (7.94 MM ID)
  • 238T41718T4171 BOLT (M6X1.0X12MM)
  • 245C28905C2890 NUT (M6X1.00 THD)
  • 257X77297X7729 WASHER (2nd TYPE)
  • 268T41388T4138 BOLT (M6X1.0X20MM)
  • 271S09941S0994 CONDUIT CLIP (USE AS REQUIRED)
  • 285P66425P6642 WIRE 1.2 m(47.25 in.)(12 gauge)
  • 299B72339B7233 LOCKWASHER (Shake Proof)
  • 3003240000324000 SCREW
  • 314F22944F2294 NUT (Part of 9F3099 Switch)
  • 329M84069M8406 CLIP-TO 8X7433 HARNESS AS ON FORE-AFT
  • 336N85896N8589 CIRCUIT BREAKER ASSEMBLY(15A)
  • 349F81259F8125 LOCKWASHER (external tooth)
  • 358M27708M2770 CLIP .5 in. (1.27 cm) I.D. hole
  • 365P31765P3176 DISCONNECT (FUEL LEVEL SWITCH)
  • 374H25584H2558 GROMMET BRACKET ASSEMBLY TO DASH
  • 388L84138L8413 TIE 5.50" LONG (USE AS REQUIRED)
  • 394M74704M7470 GROMMET
  • 404L64544L6454 BOLT (BRACKET TO RADIATOR GUARD)
  • 418T42058T4205 WASHER-ON 4M5283 BOLT IN WINDOW HINGES
  • 424P75814P7581 CLIP (FOR USE WITH 7.9MM WIDE TIE WRAP)
  • 431H32441H3244 LOCKWASHER (BRACKET TO CAB)
  • 448T46478T4647 SCREW-MACHINE
  • 456V83766V8376 SCREW-MACHINE (8-32X.25IN)
  • 468T34908T3490 NUT-WELD (M10X1.5-6H THD)
  • 476V89186V8918 BOLT (32mm LONG)
  • 486V83746V8374 SCREW-MACHINE (6-32X0.25IN)
  • 493L81873L8187 LOCKWASHER 7.24MM(.285IN.)O.D.
  • 509R26139R2613 BOSS-WELD
  • 518C56078C5607 MOUNT-ISOLATION
  • 528C56088C5608 SPACER
  • 535P56775P5677 WIRE (18 GAUGE) - (ORDER BY THE METER)
  • 545P78485P7848 NUT
  • 556V81866V8186 NUT-FULL (LARGE)
  • 569N08699N0869 WASHER 25.5MM(1.0IN)OD
  • 577T10997T1099 LINK
  • 586V18896V1889 CLIP (28.58MM ID)
  • 595P34545P3454 TERMINAL-CRIMP
  • 609G91529G9152 CLIP-SURE SEAL-TO BOSS ON BOTTOM LH OF
  • 613K87823K8782 FUSE (10A) (LOCATION X)
  • 623V47913V4791 GROMMET
  • 638T96558T9655 MOUNT-ISOLATION
  • 649X61659X6165 WASHER-HARD
  • 656V96326V9632 NUT-WELD (M6X1 THD)
  • 6612581761258176 CAM-LATCH
  • 676D46366D4636 CLIP--CLIP HOSE AS. TO 5-STEM VALVE
  • 684V41644V4164 BUSHING-TERMINAL
  • 697X25347X2534 BOLT (M6X1.0X50MM)
  • 705P72115P7211 SEAL 1.30 m (56.68 in.)
  • 716T36316T3631 NUT-HEXAGON-(15/32-32 THD)
  • 726T36326T3632 LOCKWASHER 15.08MM(.594IN.)O.D.
  • 736T36336T3633 RING-LOCKING
  • 743E52393E5239 RELAY ASSEM.
  • 757X06207X0620 WASHER-HARD (1.6MM THK)
  • 768T96588T9658 SPACER
  • 773T30453T3045 CLIP AS (FOR SS3-4 TYPE CONNECTOR)
  • 788D26768D2676 SWITCH AS (UPPER CAB LIGHTS)3412 Generator Set, 3516C Locomotive Engine, 3516C Generator Set, R2900G Load Haul Dump, 3512C Industrial Engine
  • 796V23696V2369 WIRE-(4 GAUGE)-(ORDER BY THE METER)
  • 809G43439G4343 TERMINAL-RING 4 GA. (1/4 SCREW)
  • 816V79786V7978 SCREW-MACHINE
  • 828T38448T3844 BOLT (70mm LONG)
  • 833T30483T3048 CLIP ASSEMBLY (ATTACH TO HARNESS BEHIND CAB)
  • 846V83786V8378 NUT (10-32 THD)
  • 858Y37958Y3795 BOSS
  • 869G76419G7641 SWITCH GP (ENGINE STARTER)365B Excavator, 330D LN Excavator, 143H Motor Grader, 245 Excavator, 235 Excavator
  • 876G22636G2263 SPACER
  • 8809889680988968 WASHER
  • 893T03763T0376 SWITCH ASSEM. (MAIN RELAY)375 A Excavator
  • 909X84869X8486 SCREW-MACHINE
  • 913T30473T3047 CLIP AS-TO HARNESS CONNECTORS IF 9G9154
  • 925P31755P3175 CONNECTOR ASSEM. (6 way)
  • 938X47118X4711 BOSS AS
  • 943C69693C6969 NUT-M3 HEX FULL
  • 958D95378D9537 CAP ASSEM.
  • 963V47843V4784 FUSE HOLDER
  • 973E72943E7294 CIRCUIT BREAKER AS
  • 988T53468T5346 TUBE-HEAT SHRINK
  • 9910687041068704 SUPPRESSOR AS-ARC
  • 10011453331145333 SWITCH AS-PRESSURE (HIGH/LOW)
  • 1013T30463T3046 CLIP AS-TO HARNESSES AT REAR OF CAB
  • 1026V83656V8365 SCREW-MACHINE
  • 1039G94879G9487 CIRCUIT BREAKER AS. (10 AMP)
  • 1044F56444F5644 NUT-FULL (1/4-20 THD)
  • 1052F09512F0951 LOCKWASHER (6.65MM ID)
  • 1068X58048X5804 STRAP AS-GROUND
  • 1076D93316D9331 WASHER
  • 1081V33451V3345 GROMMET
  • 1091V33461V3346 RING-SNAP
  • 1101V33441V3344 RECEPTACLE
  • 1119P18139P1813 TIMER ASSEM.
  • 1124B12554B1255 SCREW-MACHINE (1/4-20X.750 IN)
  • 1136T19516T1951 STUD AS-FASTENER
  • 1146V95056V9505 SCREW EARLY MACHINES
  • 1159X26069X2606 SCREW-ROUND HEAD
  • 11612480981248098 LATCH ASSEM.
  • 1178C96778C9677 HARNESS AS (COMPR-A/C)
  • 1186V67026V6702 CONTROL GP-VIDS/VIMS MAIN793C Truck, 784B Tractor, 785B Truck, 793B Truck, 789B Truck
  • 11910722821072282 LAMP GP-SIGNAL793C Truck, 994 Wheel Loader, 784B Tractor, 785B Truck, 793B Truck
  • 1206V66496V6649 MODULE GP-VIDS/VIMS INTERFACE793C Truck, 784B Tractor, 785B Truck, 793B Truck, 789B Truck
  • 1218X38698X3869 HINGE
  • 1225B97615B9761 SCREW-MACHINE
  • 12310876961087696 BAR
  • 12411622671162267 SWITCH GP-POSITION5130 Mining Excavator, 5230 Mining Excavator, 5130B Mining Excavator
  • 12510050751005075 CONTROL GP-MACHINE5130 Mining Excavator, 5230 Mining Excavator
  • 12612174421217442 CONTROL GP-MACHINE5130 Mining Excavator, 5230 Mining Excavator
  • 12713544841354484 CONTROL GP-MACHINE5130 Mining Excavator
  • 12810941831094183 CONTROL GP-SWING BRAKE5130 Mining Excavator
  • 12912271161227116 CONTROL GP-SWING BRAKE5130 Mining Excavator
  • 1307I53127I5312 STRIP
  • 13111531871153187 CONTROL GP-ELECTRONIC
  • 13210876841087684 BOX AS
  • 13310359711035971 CABLE AS
  • 13410359731035973 CABLE AS
  • 13510876831087683 COVER AS
  • 1367I53177I5317 DOOR AS
  • 13710834051083405 HARNESS AS
  • 13810876761087676 HARNESS AS
  • 13911957021195702 HARNESS AS
  • 14010892501089250 PLATE AS
  • 14110359691035969 WIRE AS
  • 14210876771087677 WIRE AS
  • 14310876781087678 WIRE AS
  • 14410456121045612 BAR
  • 1457I53367I5336 BRACKET
  • 14610876821087682 BRACKET
  • 14712299741229974 HARNESS AS
  • 14812578051257805 DOOR AS
  • 14912578061257806 COVER AS
  • 15012578041257804 BOX AS
  • 15112477141247714 CONTROL GP-IMPLEMENT
  • 15213302421330242 HARNESS AS
  • 15313192701319270 BOX AS
  • 15412391461239146 PLATE
  • 15512541921254192 PLATE
  • 15613178491317849 HARNESS AS
  • 15713252221325222 BAR
  • 15812773751277375 CONTROL GP-ELECTRONIC
  • 15913213251321325 BAR
  • 16013395851339585 HARNESS AS
  • 16112602561260256 HARNESS AS
Suitable for assembly
  • 1063614 WIRING GP-ELECTRONIC CONTROL
WhatsApp
wechat
Line
Email
Skype
Telegram
X
Telegram
X
Line
X
Line